(ALFORAMA) INNOVATIVE AL ALLOY FOR AIRCRAFT STRUCTURAL PARTS USING ADDITIVE MANUFACTURING TECHNOLOGY

Funding: European Union, Clean Sky Joint Undertaking 2, Horizon 2020 Programme (Grant Agreement 755610)
Partners: Lortek (Project Coordinator), University of Leuven and IMDEA Materials Institute
Region: Europe
Project period: 2017 – 2020
Principal Investigator: Drs. Srdjan Milenkovic (srdjan.milenkovic@imdea.org) and Carmen Cepeda (carmen.cepeda@imdea.org)
Project Website: http://www.alforama.eu/

The main goal of AlForAMA project is to develop an innovative High Strength Al alloy, feasible by powder metallurgy and suitable for Selective Laser Melting (SLM), with improved weldability and increased mechanical and corrosion resistance in comparison to cast grades Al alloys currently employed in Additive Manufacturing (AM).

AlForAMA project is focused on powder bed based additive manufacturing (AM) of the innovative Al alloy. Selective Laser Melting (SLM), that utilizes a laser as a thermal energy source to melt the powder has been chosen as the preferred AM technology. Development of the innovative aluminium alloy specifically designed for SLM will be mainly focused on two different aspects: on one hand, on tailoring the chemical composition to improve processability and/or mechanical response of well-established commercial aluminium alloys and, on the other hand, on defining the specific P/M processing of the raw powder material. Raw materials for SLM, produced in a powder form, will be obtained by atomization process or, alternatively, by a mixing procedure of different starting powders.

A suitable heat treatment will be defined for the developed innovative Al alloy after its SLM processing. To optimize thermal treatments AlForAMA project will consider the specific microstructural characteristics that SLM generates. SLM process development will be performed to ensure a defect free material manufacturing. A deep characterization of the new material will be carried out including mechanical, chemical and corrosion aspects. Afterwards the manufacturing process will be validated at component level.

Partners

Topic Manager

Funded by